^shadow^

Hi guys,
before I start let me say I am still doing my CCNA, said that did anyone did the Rip lab 4.
if so could you explain me how you got the task Task 7 done.

I found this on the web, tryed it..but still didnt know how to inject 0.0.0.0 to rip domain

"
Task 7 requires that we use conditional default route injection so that when network 1.0.0.0/8 is in R2’s routing table, R2 will inject default route into the RIPv2 domain. We will use an ACL and route-map to accomplish this

"
if you could share your knowlegde please
thx a lot
^shadow^

^shadow^

ont one reply, come guys....Pleaseeeeeeeeeee
:-((

smohammad

Hi,

you can inject the default using the below commands.

under router rip
default-information originate

or

under router rip
default-information originate route-map and the name you created the route-map for network

how to use route-map

create access list
then go for route-map name of map per 10
mat ip address (ACLno used to match the line)

i hope you will understand the configuration.

cruseda

Which Narbik workbook are you doing?
I don't think there is conditional route advertisiement in RIPv2. You can do it in BGP with exist, non-exist and advertise-maps for any specific neighbor, but I don't know of a way to do it in RIP.
I would certainly like to know if it is possible :-)

smohammad

cruseda,

its also supported in almost all the routing protocols, e.g. RIP,V2,EIGRP,OSPF,BGP.
try out the commands as follows.

Router rip
default-information ?
default-information origente ?

you will see the commands available and working properly.

let me know if it's help you or require more information.

check the below link for more info.

cisco.com/en/US/docs/ios/12_2/iproute/command/reference/1rfrip.html#wp1017420


Regards,
SM

IT Mehfil